Why don't the LED indicators light up or flash on my Korg Sound on Sound?
If the LED indicators do not light up or flash, the LED parameter is likely set to OFF. When this parameter is OFF, the LED indicators will not light up or flash.
General| Sampling Frequency | 44.1 kHz |
|---|---|
| Bit Depth | 16-bit |
| Recording Format | WAV |
| Recording Time | Up to 6 hours |
| Storage Media | SD card (up to 32GB) |
| Power Supply | 4 AA batteries |
| Effects | Reverb |
Discusses environmental factors affecting unit performance and power connection guidelines.
Guidelines for safe handling, cleaning, and avoiding foreign matter.
Step-by-step guide for battery installation and life.
Step-by-step guide for memory card installation.
Lists compatible card types and formatting instructions.
Procedures for powering the unit on and off.
Identifies and describes various input/output jacks on the unit.
How to connect and select guitars, microphones, or line devices.
Steps to create and start recording a new song file.
Detailed guide to perform overdubbing.
Step-by-step guide for using the built-in tuner.
Explains settings for input level, low cut, and tone.
Details MIC GAIN, N-GATE, and P-IN-PWR settings.
Details on adjusting effect parameters and their application point.
Instructions for formatting memory cards for the first time.
Instructions for downloading and installing system updates.
Calibrates the touch slider for accurate response.
Initializes the recorder to factory default settings.
Lists and explains various error messages.
Lists and explains more error messages.
Solutions for unit not powering on or dark LCD.
Troubleshooting button, slider, and sound problems.
Addresses issues with input level, tone, and noise.
Solutions for cannot record, interrupted sound, and unit not starting.
To Next Page
