Korg MiniPitch - MiniPitch Overview and Usage; Parts of the MiniPitch; Tuning Guide; Autoguide Mode

2
Parts of the MiniPitch
C
E
G
A
Battery tray
Clip
Power
button
String name
indicator LED
LED meter
Display
10‒15
mm
C
E
A
G
Since the MiniPitch is small and lightweight, infants may
try to put it in their mouths. Keep the MiniPitch out of the
reach of infants.
Installing the battery
Make sure to turn the power off
before you replace the baery.
When the battery runs low, the
LED meter will no longer operate
smoothly. Replace the battery as
soon as possible to ensure accurate
tuning.
1. Slide out the baery tray, which
is combined with the display.
2. Insert the baery, making sure to
observe the correct polarity.
3. Return the battery tray to its
original position.
Attaching to the instrument and range of motion
The MiniPitch tunes by picking up
the vibrations of the instrument.
For the most accurate tuning, be
sure to aach the MiniPitch to the
head stock of your instrument.
In addition, the display can be
moved as shown below, so that it
is easier to read.
110°
The MiniPitch may be damaged if you apply excessive
force within its range of motion, or aempt to move it be-
yond its intended range of motion.
Please carefully aach the MiniPitch to your instrument.
Leaving the MiniPitch aached for a long time may dam-
age or mark the instrument's surface.
Depending on various factors such as agerelated change
or the surface nish, there is a possibility that your instru-
ment may be damaged by aaching this product.
Tuning
1. Press the power buon to turn on the power.
2. Play a single note with the string that you want to tune.
3. Roughly tune the string until the string name indicator
LED for the string you're playing lights up.
4. Tune the instrument until the center of the LED meter
lights up. The lower side of the LED meter will light up if
your instrument is at, and the upper side will light up if
your instrument is sharp.
C
E
G
A
5. To turn o the power, press the power buon.
If approximately three minutes pass without the MiniPitch
detecting any sound, the power will turn o automatically
(Auto power-o).
The meter may respond to vibrations it picks up from the
environment; however, this will not affect tuning of the
instrument.
Autoguide mode
In Autoguide mode, you can move on to tuning the following
string once a string is in tune, starting from the 4th string (G).
This mode helps reduce tuning time and allows ukulele begin-
ners to tune with condence.
1. Press the power buon to turn on the MiniPitch.
2. Hold down the power buon to enter the Autoguide mode,
and a string name indicator LED (G) blinks.
3. Play the string indicated by the blinking string name indica-
tor LED and tune it.
4. When the center of the LED meter lights up to indicate that
the string is tuned, the next string name indicator LED (C)
blinks.
5. Repeat these steps until all four strings are tuned.
6. When
all strings have been tuned,
Autoguide mode is exited.
TIP
To cancel Autoguide mode, breiy press the power buon.
Autoguide mode does not support Low-G tuning.
Specications
CR2032
+
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
CAN ICES-3 B / NMB-3 B.
Scale
12-note equal temperament (A4=440Hz, xed)
Detection
range
compatible with standard G, C, E and A tuning,
and Low-G tuning (except in Autoguide mode)
(sine wave) G3 (196.00Hz)–A6 (1760.00Hz)
Precision
+/-1 cent
Power supply
coin-type lithium baery (CR2032) x 1
Baery life
approximately 100 hours (continuous A4 input)
Dimensions
(W x D x H)
43 × 29 × 24 mm / 1.69 × 1.14 × 0.94 inches
Weight
13 g / 0.46 oz. (including baery)
Included
items
Owner’s manual, coin-type lithium battery
(CR2032) x 1
* Specifications and appearance are subject to change without
notice for improvement.
En