monotribe System Firmware Update Instructions
3
Perform the update
1. Turn the power on while pressing the FLUX, HH and STEP 1 buttons.
The SYNTH, BD and SN LEDs will light to show your monotribe has entered update mode.
2. Start the playback of MONOTRIBE_SYS_0211.wav to begin updating.
Make sure the volume of the playback device has been turned up.
STEP LEDs 1-8 will indicate the update progress.
Make sure the update file is played from the beginning.
When using a computer, any other system sounds (e.g. email notification) will cause the update
to fail. Make sure all other applications are shut down and do not operate you computer during
the update.
The update will t ake approximately two minutes . Do not turn your m onotribe off or stop
playback while update is in progress.
If the update fails, the FLUX, REC and PLAY LEDs will start blinking. If this happens, observe
“Tips” at the end of this document and repeat the update from step 1.
3. When the update has been successfully completed, the PLAY LED alone will be lit. Now, turn the
power off.
To Next Page
Loading...
