Korg POLY-61 - Tape Interface Operations

8. TAPE INTERFACE
1) S ETTING
Connect POLY-61 to cassette recorder in following
way.
(1) To tape -»Tape recorder LINE IN (or MIC IN)
(2) From tape ■ *- Tape recorder LINE OUT (or
EARPHONE OUT)
2) SAVE (Perform to prevent erasure of user's data.)
(1) Set TAPE ENABLE to ENABLE position; confirm
7 ft ‘pf indication and no sound from keyboard.
(2) Begin recording on tape recorder, press SAVE
switch; confirm 'jHut indication for a few
seconds, followed by j /-/P p-
3) VERIFY.
(1) Rewind tape from above. TAPE ENABLE should
be at ENABLE position.
(2) Press VERIFY switch d r F d is indicated); play
tape.
(3) Confirm that after a few seconds the indication
flickers a bit and then uO O d appears.
(4) If £ r r appears, adjust tape recorder volume and
tone controls, etc., and repeat the procedure several
times.
4) LOAD.
(1) Put supplied "factory patch" tape in recorder.
(2) Set TAPE ENABLE and WRITE ENABLE to
ENABLE positions.
(3) Press LOAD ([,0 0 d i s indicated) and play tape.
(4) Confirm slight flicker after a few seconds and
indication.
(5) If per appears, check tape recorder output level,
tone settings, etc., and try again several times.
24