Korg POLYSIX - Page 12

12
(Control settings not storable in the memory)
OUTPUT/TUNE/BEND
INTENSITY
VOLUME
BEND
TUNE
OUTPUT
LOW
HIGH
OFF
1
2
3
4
1) TUNE
Adjusts pitch over a range of +/-50 cents (1/2 semitone). Use this knob when you want to tune the Polysix to
match other instruments.
2) BEND
Knob adjusts the range of pitch bends controlled by wheel to a maximum of +/-13 semitones.
3) 4) OUTPUT
Knob adjusts final output volume. The switch (4) should be set to LOW for guitar or keyboard amps; set to
HIGH for audio amps, audio mixers, or PA console inputs. At OFF, you can use headphones to monitor the sound
without any output going to the amp or PA.