Precautions before assembly
Before you begin to assemble the stand, please keep the following in mind:
To assemble the stand, two people are needed. Failing to do so may damage the instrument and cause injury.
When placing the instrument on the stand, be careful not to pinch your hands.
Be sure to follow the steps in order and make sure that the parts are assembled in the correct orientation and
position.
Do not apply weight to the edge of the instrument before tightening the screws, otherwise, the instrument may
fall down.
Assembly instructions
1. Open the packing carton and take out the contents. Remove the stand (B) from the package by grabbing it by
the four brackets (a). Lay it on the ground, with the legs on top (see illustration).
2. Remove the protective sheet, and keep it in a safe place for future use.
3. Slightly lift the stand, and push the spring bolt (b) located under the tubing.
4. Once the spring bolt has been extended, raise the leg (c), until you hear a ‘click’. At this point, the spring bolt (b)
is automatically retracted, and the leg is fixed in place. Please repeat the same procedure for all four legs.
To Next Page
Loading...
