9. If the instrument and the stand are correctly aligned, the screws (o) should fit into the threaded nuts of the holes
(n). If this does not happen, align the instrument and stand again. Once the screws are inside the threaded nuts,
tighten them to attach the instrument to the stand.
10. Be sure all screws are tightened, and all brackets correctly inserted.
11. Place the instrument in the location where it will be played.
Disassembly
If you need to pack up the instrument, reverse the assembly order by which the instrument was attached to the stand
and the stand was assembled. For improved protection, we suggest you also replace the protective sheet (see step
2). Please use the included loop fastener tapes (x) to secure the stand legs (a, c) during transport and avoid any
damage.
To Next Page
Loading...
