toward you.
7. Adjust the height of the feet (g), by turning them by hand and leveling the stand on each side, even if it is not
completely even. We suggest you prevent the nut (h) from turning with the help of the supplied 11/16” wrench
(i). After adjusting each of the feet, make sure that the nut (h) touches the leg’s border.
8. Two people are needed to lift the instrument (A), and attach it to the ST‑SV1‑BK stand (B). While one person
prevents the instrument from falling down, the other should make the small rubber foot (k) under the instrument
line‑up to the concave side of the bracket (f), and the screw (l) under the instrument with the space left on the
side of the convex side of the bracket (m). Align the holes (n) under the instrument to match the screws (o) of
the stand.
Warning: During this step, do not apply weight to the instrument, otherwise it may fall down.
To Next Page
Loading...
