TRITON Le EasyStart
5
4. CURSOR ► to “Input 1 BUS”
Ä Set this value to “L/R” Ä CURSOR to the “Create” edit cell and set the “Range” value
to “001”.
5. Press [F2] (“Rec”), and in “Sample Setup”, CURSOR ► to “Mode” and set to “L-Mono”.
6. CURSOR ▼to “REC Setup”, and highlight “Mode”, and set to “Auto”
Ä CURSOR ► to “Threshold” and set to a value
of “-30dB”
Ä CURSOR ▼to “Pre Trigger” and set to “5ms”.
7. Press the [REC/WRITE] key to “arm” the sampler, and then speak into the microphone. If “ADC Overload” flashes above
the “level indicators”, lower the rear panel LEVEL control until this message no longer flashes
Ä CURSOR ►to the
“Recording Level” “Fader” and adjust with the DIAL while speaking into the mic. Set this for a “hot” signal level, but watch
and adjust if the display indicates, “CLIP”.
8. Press [F1] (“Sample”)
Ä Press the [START/STOP] key and say the word, “Sampling” Ä press [START/STOP] again to
stop sampling, and then press [F6] (“CREATE”). Note that the “keyboard” display moves to the next key after you press
“CREATE”.
9. Press the [REC/WRITE] key
Ä Press the [START/STOP] key and say, “is easy” Ä press [START/STOP] again to stop
sampling, and then press [F6] (“CREATE”).
10. Press the [REC/WRITE] key
Ä Press the [START/STOP] key and say, “with” Ä press [START/STOP] again to stop
sampling, and then press [F6] (“CREATE”).
11. Press the [REC/WRITE] key
Ä Press the [START/STOP] key and say, “TRITON Le” Ä press [START/STOP] again to
stop sampling, and then press [F6] (“CREATE”).
12. That’s it! Now play the keyboard: play each note (half-step) from C2 to D#2, and you’ll hear the sampled words, “Sampling
is easy with TRITON Le”.
…Continue by sampling through one of TRITON Le’s 89 Insert Effects:
13. Press [F3] (“In/Pref”) Ä CURSOR to Input 1’s “BUS:” and select “IFX” Ä Press the [MENU] key, and then press [F7] to
select “IFX”
Ä Press [F8] to “Open” this page.
14. CURSOR to “OFF” and set to “ON”
Ä CURSOR to highlight the “00 No Effect” edit cell Ä Use the numeric keypad, to
enter 5 > 2, then press the [ENTER] key (“52: Reverb Hall”)
Ä Speak into the microphone to hear the effect being applied
Ä Press [F4] (“IFX ”) to view and edit the effect parameters.
15. Press the [MENU] key
Ä Press [F1] (“Rec”) Ä Press [F8] to “Open” this page Ä Press [F1] (“Sample”).
16. Press [F6] (“CREATE”) to make a new index in the multisamples
Ä Press [F2] (“Rec”) Ä Press the [REC/WRITE] key to
“arm” the sampler
Ä Speak into the mic and adjust the recording level as needed (see step 7 above) Ä Press the
[START/STOP] key, speak to sample
Ä Press [START/STOP] again to stop sampling. The new sample will playback on
key E2 – the next available index.
To Next Page
Loading...
Need help?
General
