Korg Wavedrum - Page 13

Parameter list Edit 1 ( Ed1)
13
6. Velocity curve diagram 7. Pressure curve diagram
7. Pressure
Curve
( P. Cr )
h d. A 0 . . . 5
Selects a curve that
determines how the vol-
ume or tone of the algo-
rithm will be affected by
pressure applied to the
head. (See diagram
below.)
h d. P 0 . . . 5
S*: Selects a curve that
determines how the vol-
ume or tone of the head
PCM instrument will be
affected by pressure
applied to the head. (See
diagram below.)
D*: ---
---
r . P 0 . . . 5
S*: Selects a curve that
determines how the vol-
ume or tone of the rim
PCM instrument will be
affected by pressure
applied to the head. (See
diagram below.)
D*: ---
8. Pressure
Tune
( P. tn )
---
hd. P -12. . .12
S*: Specifies how the
pitch of the head PCM
instrument will be
affected by pressure
applied to the head. This
setting specifies the num-
ber of semitones (up to +/
-1 octave) by which the
pitch will change when
the maximum pressure is
applied.
D*: ---
---
r . P -12. . .12
S*: Specifies how the
pitch of the rim PCM
instrument will be
affected by pressure
applied to the head. This
setting specifies the num-
ber of semitones (up to +/
-1 octave) by which the
pitch will change when
the maximum pressure is
applied.
D*: ---
9. Pressure
Decay
( P. dc )
---
hd. P -50. . . 50
S*: Specifies how the
decay time of the head
PCM instrument will be
affected by pressure
applied to the head. This
setting specifies the
change produced when
the maximum pressure is
applied.
D*: ---
---
r . P -50. . . 50
S*: Specifies how the
decay time of the rim
PCM instrument will be
affected by pressure
applied to the head. This
setting specifies the
change produced when
the maximum pressure is
applied.
D*: ---
10. Reverb
( rEb )
typ 00. . .10
Selects the type of
reverb.
00: Off, 01: Slap,
02: Spring1,
03: Spring2, 04: Plate,
05: Garage,
06: Chamber,
07: Canyon, 08: Room,
09: Studio, 10: Hall
baL 000. . .100
Specifies the effect level.
dEp 00. . . 90
Specifies the reverb
decay time.
HdP 000. . .100
Specifies the amount of
high-frequency damping.
11. Delay
( dLY )
ti 000. . . 200
Specifies the delay time
in 0.01 second units, up
to a maximum of 2 sec-
onds.
baL 000. . .100
Specifies the effect level.
Fb 00. . . 99
Specifies the amount of
feedback.
HdP 000. . .100
Specifies the amount of
high-frequency damping.
Page#.
Parameter
Button 1 Button 2 * Button 3 * Button 4 *
Soft
Min.
Max
Strong
0
1
2
3
4
5
6
7
8
9
Soft
Min.
Max
Strong
0
1
2
3
4
5