What causes time-out power issues in Kostal inveor Controller?
A time-out power issue in your Kostal Controller may be caused by operating with 24 V without mains feed-in. Ensure proper mains feed-in.
What to do if parameter distributor is not working in Kostal Controller?
If you're having issues with the parameter distributor in your Kostal Controller, it might be due to an incomplete parameter set. Complete the parameter set to resolve this.
What does STO inputs plausibility mean for Kostal inveor Controller?
If you're encountering STO inputs plausibility issues with your Kostal Controller, it suggests an incorrect activation of the STO inputs. Check corresponding external wiring to address this.
What to do if motor connection is disrupted in Kostal inveor Controller?
If the motor connection is disrupted in your Kostal Controller, check the phases or motor connections and connect correctly when necessary.
What to do if Kostal Controller shows a start-up error?
Check motor connections/check motor and controller parameters; if necessary, disable error (5.082).
What does I2T motor protection shut-off mean for Kostal Controller?
An I2T motor protection shut-off in your Kostal Controller indicates a permanent overload condition. Reduce overload conditions to resolve this.
What causes communication errors between application and power in Kostal Controller?
Communication issues between the application and power components of your Kostal Controller can be caused by EMC interference. Check the communication lines and components to address this.
What causes IGBT trip in Kostal inveor Controller?
An IGBT trip in your Kostal Controller can be caused by a short circuit in the motor or motor feed line, or by controller settings. Check the motor and controller settings to troubleshoot.
What should I do if my Kostal inveor Controller experiences a power failure?
If your Kostal Controller experiences a power failure, it could be due to grid fluctuation or an interruption in the grid voltage. Monitor the grid voltage to diagnose the issue.
What causes excess IGBT module temperature in Kostal Controller and how to resolve it?
If your Kostal Controller is showing excess IGBT module temperature, it may be due to insufficient cooling, low motor speed and high torque, or a switching frequency that is too high. Improve cooling and adjust settings to resolve this.
General| Brand | Kostal |
|---|---|
| Model | inveor |
| Category | Controller |
| Language | English |
Contains essential warnings and precautions for safe handling and operation of the drive controller.
Crucial safety guidelines and precautions to be followed before and during the installation.
Step-by-step guide for mechanically installing the drive controller directly onto the motor.
Detailed instructions for mounting the drive controller in a wall-mounted configuration.
Essential safety measures and precautions to be observed during the commissioning phase.
Critical safety warnings and precautions when adjusting operational parameters for safe use.
To Next Page