How do I fix a ground leak in my Kostal inveor?
If you're experiencing a ground leak with your Kostal Controller, it's likely due to an insulation fault. Check for insulation faults to resolve the issue.
How to troubleshoot overvoltage of intermediate circuit in Kostal inveor?
An overvoltage in the intermediate circuit of your Kostal Controller might be due to feedback from the motor in generator mode, mains voltage being too high, a faulty setting for the rotation speed controller, a brake resistor that is not connected or is defective, or ramp times that are too short. Verify the settings and connections to resolve this.
What causes undervoltage of intermediate circuit in Kostal Controller?
An undervoltage in the intermediate circuit of your Kostal Controller can be caused by mains voltage that is too low, a defective mains connection, or wiring issues. Check the mains voltage and wiring to address this problem.
Why is my Kostal inveor motor overheating?
If your Kostal Controller's motor is experiencing excess temperature, this could be due to an overload (such as high torque at low motor speed) or a high ambient temperature. Reduce the load and check the ambient temperature to mitigate this issue.
What to do if there is an overcurrent in my Kostal inveor Controller?
If your Kostal Controller is showing an overcurrent error, it could be due to several reasons: the motor is stalled, there's an issue with the motor connection, the speed controller setting is incorrect, the motor parameters are off, ramp times are too short, or the brake isn't open. Inspect the motor connections and settings to resolve this issue.
How to correct external fault 1 on Kostal inveor?
General| Brand | Kostal |
|---|---|
| Model | inveor |
| Category | Controller |
| Language | English |
Contains essential warnings and precautions for safe handling and operation of the drive controller.
Crucial safety guidelines and precautions to be followed before and during the installation.
Step-by-step guide for mechanically installing the drive controller directly onto the motor.
Detailed instructions for mounting the drive controller in a wall-mounted configuration.
Essential safety measures and precautions to be observed during the commissioning phase.
Critical safety warnings and precautions when adjusting operational parameters for safe use.
To Next Page