Kraft Powercon PRX3 - User Manual

KraftPowercon Sweden AB, Hjalmar Petris väg 49, S-352 46 Växjö, Sweden, Tel: +46 470-705200, Fax: +46 470-705201,
www.kraftpowercon.com
This manual must be read before installation, use or work on the product.
This product contains dangerous voltages that when touched can cause electric shock, burns
or death.
The product must be installed by qualified personnel and according to the installation
instructions. Service may only be performed by authorized service personnel. The protective
covers and contact safety devices inside the equipment may only be removed by authorized
service personnel.
The power must always be disconnected in a safe way before starting any
service/maintenance.
Warning for reverse voltage. Power is supplied from several sources.
Manual for
Charging Rectifier
type PRX3
SAFETY INSTRUCTIONS
Manual: 9-1636-B
P/n: 0001085

Summary

Presentation

Safety Instructions

Technical Data

Assortment

Lists different models of charging rectifiers and their specifications.

Electrical Data

Details electrical input and output characteristics of the rectifier system.

Environmental Data

Specifies operating and storage conditions for the equipment.

Mechanical Data

Covers design, dimensions, and weight of the equipment.

Conformity With Standards

Lists relevant industry standards and certifications for compliance.

Functional Description

General

Provides an overview of the charging rectifier system and its components.

Rectifier Modules

Explains the functionality, controls, and indications of individual rectifier modules.

Functions of Complete Charging Rectifier

Describes the overall system functions like float and equalizing charging modes.

Operation

General

Outlines the primary operation modes and controls of the rectifier system.

Rectifier Modules

Details how to operate and interpret the status indicators of rectifier modules.

Monitoring Unit PCM2

Explains the usage and features of the monitoring unit for system control.

Installation Instructions

Safety Instructions

Crucial safety precautions for installation procedures to prevent hazards.

General

General guidelines and requirements for the installation process.

Storage and Protection

Proper methods for storing and protecting the equipment before installation.

Mounting

Instructions on how to physically install the cubicles and modules.

Electrical Installation

Steps for connecting the electrical components and wiring the system.

Commissioning

Safety Instructions

Safety measures to be observed during the commissioning phase.

Preparatory Inspection

Pre-commissioning checks and verifications of the installed system.

Powering Up

Procedures for powering on the system and its components correctly.

Checking the Charging Voltage

Verifying the correct charging voltage settings against battery specifications.

Checking the Settings

Confirming system configuration, parameters, and time settings.

Checking the Outputs

Verifying system outputs, alarm signals, and fan control functionality.

Maintenance

Annual Inspection

Procedures for yearly inspection and routine maintenance of the system.

Fault Tracing and Service

Safety Instructions

Safety guidelines for personnel performing troubleshooting and service.

Fault Tracing Alarms

Methods for tracing faults indicated by system alarm messages.

Other Fault Tracing

General fault diagnosis and troubleshooting steps for system issues.

Instructions for Replacing Rectifier Module During Operation (Hot Swap)

Step-by-step guide for hot-swapping rectifier modules without system shutdown.

Kraft Powercon PRX3 Specifications

General

Frequency	50/60 Hz
Operating Temperature	0°C to +40°C
Storage Temperature	-20°C to +70°C
Output Voltage	12V DC
Protection	Overvoltage, Overcurrent, Short Circuit