Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your PT-871xr.
To achieve specified extension distances, use the recommended Kramer cables to connect AV equipment to the PT-871xr (available at
www.kramerav.com/product/PT-871xr).
Using third-party cables may cause damage!
Step 5: Connect the power
Connect the 12V power adapter to the PT-871xr and plug it into the mains electricity. This device provides power to its
counterpart via DGKat 2.0. Each device can provide or accept power over cable (PoC) via DGKat 2.0.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
• For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
• There are no operator serviceable parts inside the unit.
Warning:
• Use only the power cord that is supplied with the unit.
• Disconnect the power and unplug the unit from the wall before installing.
Step 6: Technical Specifications
On a female HDMI connector
On a female RJ-45 connector
Transmitted Data Bandwidth
Up to 18Gbps (6Gbps per graphic channel)
3840x2160@60Hz (4:4:4) 24bpp at high compression level
4096x2160@60Hz (4:4:4) 24bpp at standard compression level
HDMI 2.0, HDCP 2.2, HDR 10
Standard Compression
Level
Up to 40m (130ft) at 4K@60Hz (4:4:4)
Up to 70m (230ft) at 4K@60Hz (4:2:0) or full HD (1080p @60Hz 36bpp)
Up to 60m (200ft) at 4K@60Hz (4:4:4)
Up to 70m (230ft) at 4K@60Hz (4:2:0) or full HD (1080p @60Hz 36bpp)
0° to +40°C (32° to 104°F)
-40° to +70°C (-40° to 158°F)
10% to 90%, RHL non-condensing
1 Power adapter, 1 power cord
Specifications are subject to change without notice at www.kramerav.com
To Previous Page
Loading...
