Kramer VM-3HN

8
VM-3HN - Connecting the VM-3HN
4.2 Force RGB Mode
The VM-3HN toggles between “Normal” and “Force RGB” modes.
To toggle:
 Press the EDID button for three seconds
All input and outputs LEDs flash depending on the selected mode:
 In “Normal mode” (not forcing RGB), the LEDs flash once
 In “Force RGB mode”, the LEDS flash four times
Note: After setting the Force RGB mode you must re-read the EDID from the
display to update the Force RGB change.
Powering on the device identifies the mode as follows:
 In “Normal mode” (not forcing RGB), the LEDs flash once
 In “Force RGB mode”, the LEDS flash four times.
The default mode is "Normal".