Kramer VM-4H2

VM-4H2 - Connecting the VM-4H2 7
4 Connecting the VM-4H2
Always switch off the power to each device before connecting it to
your VM-4H2. After connecting your VM-4H2, connect its power and
then switch on the power to each device.
You do not have to connect all the inputs and outputs, connect only
those that are required.
To connect the VM-4H2, as illustrated in the example in Figure 2
, do the following:
1. Connect an HDMI input source (for example, a 4K Blu-ray player) to the
HDMI IN connector.
2. Connect the four OUTPUT connectors to up to four HDMI acceptors, as
follows:
Not all outputs need to be connected.
 HDMI OUT 1 connector to HDMI acceptor 1 (for example, a 4K display
with speakers)
 HDMI OUT 2 connector to HDMI acceptor 2 (for example, a 4K display
with speakers)
 HDMI OUT 3 connector to HDMI acceptor 3 (for example, 4K plasma
display)
 HDMI OUT 4 connector to HDMI acceptor 4 (for example, 4 K plasma
display)
3. Connect the 5V DC power adapter to the power socket unit and then
connect the adapter to the mains electricity (not shown in Figure 2
).
See Section 3.3 for the state of the LED indicators during and after powering
on.