Always switch off the power to each device before connecting it to your
VP-472. After connecting your VP-472, connect its power and then
switch on the power to each device.
To connect the VP-472 as illustrated in the example in Figure 2:
1. Connect the SDI source (for example, an SDI camera) to the SDI IN BNC
connector.
2. If required, connect the SDI LOOP BNC connector to the SDI acceptor (for
example, an SDI display).
3. Connect the HDMI OUT connector to the HDMI acceptor (for example, a
plasma display).
The VP-472 outputs on both the SDI OUT and HDMI connectors simultaneously
4. Connect the 5V DC power adapter to the power socket and to the mains
electricity (not shown in Figure 2).
To Next Page
Loading...
