In the Network Settings menu is a submenu Status Announce Setting. This feature is activated when
Enable Status Announce is switched on. VP-792 will then send messages out continuously through
RS232 and TCP/IP to signal system condition. Server address and port of the PC where to send the
message need to be entered. The Refresh Rate determines the rate at which the VP-792 status
condition and the message entered under Custom Data being sent out.
3.9.8. Factory Defaults
This button let you restore all settings to the default values of the VP-792, thus, provide a means to get
back to a known (good) system state. A requestor will come up and ask to confirm prior to actual
restore.
To Next Page
Loading...
