Commissioning
12
Electrical connection
Make sure that the master switch is switched off (position „0“).
Plug in the power cable of your high-pressure cleaner.
The voltage given on the specification plate must match the mains voltage. You can
find the specification plate on the front right-hand side of the appliance.
The machine is supplied with a power cable and plug.
The plug must be connected to a properly installed electrical so-
cket with earthing and have a 30 mA FI residual current circuit
breaker. The socket must have a neutral 16A fuse on the mains
side.
If an extension cable is used, it must have an earth line that is properly connected to
the plug connections. The lines in the extension cable must have a cross section of at
least 1.5 mm². The plug connections must be of spray protected design and may not
lie on a wet surface. (If the extension cable is longer than 10 m the minimum cross
section is 2.5 mm²)
Important!
Extension cables that are too long cause a drop in the voltage and
thus interruptions in operation. If you are using a cable drum, the
cable must always be fully unwound.
Commissioning
Secure the machine by applying the brake (see page 8)
and check the oil level of the high pressure
pump.
Do not start the machine if there is no oil on
the dipstick. Fill oil if necessary. See page 18.
Use EL heating oil (DIN 51603) or Diesel fuel only.
Unsuitable fuels, such as petrol, may not be used (danger of
explosion).
Fill the fuel tank with light heating oil prior to use.
To Next Page
Loading...
Need help?
General
