17
Care and Maintenance
1
Care and Maintenance
Care and maintenance is required to keep the machine in good working order, and
to allow you to enjoy the machine for as long as possible.
IMPORTANT!!!
Always remove the plug before working on the machine!
Only use original Kränzle spare parts
What to do!
- Weekly, or after approx. 40 hours of operation
Check the oil level of the high pressure pump. (see page 13)
If the oil level is too low, add oil until the oil level is between the two markings on
the oil measuring rod.
Change the oil (see page 19) if it has a grey or whitish appearance. The oil should
be disposed of responsibly.
Check the filter in front of the float valve in the water tank and the fuel filter
in front of the solenoid valve. Clean the filters if necessary.
- Yearly, or after approx. 500 hours of operation
Desulphurise and decarbonize the heating coil.
Check if the heating coil is calcified (see page 20).
Check the oil burner and ignition system.
Clean the oil nozzle, oil filter, solenoid valve and filter, clean and adjust the
ignition transformer, ignition cable and ignition electrodes and replace defective parts.
Change the oil
Changing the oil
To do this, take the oil drainage hose (1)
connected to the oil drain screw, from the inside
of the machine and open the red oil filler cap on
the top side of the black oil reservoir. Open the
cap at the end of the hose. Drain off the oil into
an oil pan and dispose of it responsibly.
Close the end of the hose.
Refill with oil.
To Next Page
Loading...
Need help?
General
