11
EN
Step 3.2 (Inlet option)
If an air intake is connected, the replace must then be placed on a dedicated base, rst placing the
base as close as possible to where the unit will eventually be placed, leaving at least 0.5 m of free space
on either side of the unit for the free installation of the installation elements. The replace must be
placed on a structure on a base, e.g. on bricks, install the lower installation panels according to the
scheme in steps 4 and 5, and then remove the bases.
If this is not an option with an intake, proceed to the next step.
W przypadko podłączenia dolotu powietrza,
kominek należy ustawić na konstrukcji np. na cegłach,
zamontować dolne panele i usunąć podstawki.
To Next Page
Loading...
