EasyManua.ls Logo

Kraus FS-1000-B - User Manual

Kraus FS-1000-B
18 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
All-in-One Filtration Set
FS-1000 / FS-1000-B
R
INSTALLATION MANUAL
www.kraususa.com I Toll Free: 1.800.775.0703 I © 2024 Kraus USA Plumbing LLC I REV. January 3, 2024

Table of Contents

Questions and Answers

  • K
    Kristen HamiltonAug 11, 2025
    How to fix water leaks between the filter head and the filter cartridge in Kraus FS-1000-B?
    • A
      April MorganAug 12, 2025
      If water is leaking between the filter head and the filter cartridge in your Kraus Water Filtration System, it could be due to a damaged, dirty, or misplaced O-ring. To resolve this, turn off the water supply and relieve the water pressure. Remove the filter cartridge and inspect the O-rings for any damage or debris, making sure they are correctly positioned. Reinstall the filter cartridge, turn the water supply back on, and check to see if the leak has stopped.
  • L
    Leonard FloresAug 22, 2025
    What to do if water leaks at a threaded connection in Kraus Water Filtration Systems?
    • K
      kthomasAug 22, 2025
      If you notice water leaking at a threaded connection in your Kraus Water Filtration System, the connection might be damaged or dirty. First, turn off the water supply and relieve the water pressure. Next, disconnect the fitting and check the seal for any damage or debris. Remove any debris or replace the damaged fitting if needed. Reconnect the fitting securely, but be careful not to overtighten it. Finally, turn the water supply back on and check for any leaks.
  • A
    astewartSep 1, 2025
    Why is my Kraus Water Filtration System leaking at a tubing connection?
    • P
      pprinceSep 1, 2025
      If your Kraus Water Filtration System is leaking at a tubing connection, it might be because the tubing isn't cut straight or is damaged. Here's how to fix it: 1. Turn off the water supply and relieve the pressure. 2. Remove the Quick Connect Lock Tab. 3. Press the collar around the fitting where the leak is and gently pull the tubing out. 4. Use a sharp utility knife to cut off about 1/2 inch (13 mm) from the end of the tubing to ensure a clean, square edge. 5. Push the tubing back into the fitting. 6. Turn the water supply back on and check for leaks.

Kraus FS-1000-B Specifications

General IconGeneral
ModelFS-1000-B
BrandKraus
CategoryWater Filtration Systems
InstallationUnder Sink
Faucet IncludedYes
TypeUnder Sink
Filter Life6 months
Filter TechnologyCarbon Block
Reduces ContaminantsChlorine
Housing MaterialPlastic

Related product manuals