Kraus FS-1000 - User Manual

Questions and Answers

S
Sarah MontgomeryAug 11, 2025
How to fix water leaks between the filter head and the filter cartridge in Kraus FS-1000 Water Filtration Systems?
- A
  Angela FosterAug 11, 2025
  If water is leaking between the filter head and the filter cartridge in your Kraus Water Filtration System, it could be due to a damaged, dirty, or misplaced O-ring. To resolve this, turn off the water supply and relieve the water pressure. Remove the filter cartridge and inspect the O-rings for any damage or debris, making sure they are correctly positioned. Reinstall the filter cartridge, turn the water supply back on, and check to see if the leak has stopped.
T
Timothy AndrewsAug 22, 2025
What to do if water leaks at a threaded connection in Kraus FS-1000?
- J
  Joseph ShermanAug 22, 2025
  If you notice water leaking at a threaded connection in your Kraus Water Filtration System, the connection might be damaged or dirty. First, turn off the water supply and relieve the water pressure. Next, disconnect the fitting and check the seal for any damage or debris. Remove any debris or replace the damaged fitting if needed. Reconnect the fitting securely, but be careful not to overtighten it. Finally, turn the water supply back on and check for any leaks.
S
Stephanie KingAug 31, 2025
Why is my Kraus Water Filtration System leaking at a tubing connection?
- R
  Rachael FoxSep 1, 2025
  If your Kraus Water Filtration System is leaking at a tubing connection, it might be because the tubing isn't cut straight or is damaged. Here's how to fix it: 1. Turn off the water supply and relieve the pressure. 2. Remove the Quick Connect Lock Tab. 3. Press the collar around the fitting where the leak is and gently pull the tubing out. 4. Use a sharp utility knife to cut off about 1/2 inch (13 mm) from the end of the tubing to ensure a clean, square edge. 5. Push the tubing back into the fitting. 6. Turn the water supply back on and check for leaks.