12
Step 7.
Display & Reset:
After installing new filters push and hold the settings button for 3 seconds. Filter 1 icon will
blink. Push the reset button and hold for 3 seconds and the icon will reset to full capacity. Push
the settings button again and filter 2 icon will blink. Push and hold the reset button for 3
seconds and the icon will reset to full capacity. Push the settings button to exit the reset mode.
Flush:
When installing new filters, you must flush for a minimum of 10 minutes, the flush icon will blink
until done. If filters have not been used for more than 3 days, the flush icon will blink. Flush for
a minimum of 5 minutes.
Potable Water Icon:
The Potable Water icon will blink when the filter is ready for use.
! CAUTION - Do not drink the water before the Potable Water icon blinks.
Filter Icon:
The Filter Icon represents the 2 filters for the FF-1000 filter unit. Indication
of 5 bars show a new filter, 100% capacity, 4 bars 50-75%
capacity, 3 bars 25-50% capacity, 2 bars 5-25% capacity,
1 bar less than 5% capacity. When below a 5% capacity the Filter Icon
will blink, and the unit will buzz every 6 seconds when the water is flowing.
At 0% filter capacity the icon will blink constantly.
Battery Icon:
When the batteries reach below 10% capacity the
Battery Icon will blink and a warning light will come on.
Cleaning in Progress Icon:
The conditions that initiate the cleaning process are when the filter has not been used for three
days or after the filters are replaced. If any of the two conditions are met, the "cleaning" starts.
The "Cleaning in Process" icon starts to blink. The cleaning takes ten minutes. It stops blinking
after ten minutes when the cleaning is completed.
Potable Water
Replace Filter Soon
Cleaning in Progress
1
!
2
Filter Icon
0% Capacity
Battery Icon
Full
Battery
Low
Battery
Settings Button
Reset Button
To Next Page
Loading...
Need help?
General
