8
Step 2.
Using the mounting template, mount
the manifold. Align the mounting
holes of the manifold at the proper
mounting location. Mark the hole
locations with a permanent marker.
Place the manifold aside and pre-drill
the mounting holes, if necessary,
depending on the fasteners selected.
Partially thread the screws into the
cabinet wall and slide the manifold
over the screws. Secure the manifold
by tightening the screws.
NOTE: This system is designed for
vertical installation. Make sure that
the bottom of the filter cartridge will
be at least 2" from the bottom of the
cabinet.
Fasteners
Screws
! CAUTION - To avoid the risk of
personal injury, wear safety glasses
and cut resistant gloves with non-slip
grip when drilling.
wall
Position drill holes
as indicated
7.87"(200mm)
Cabinet
Top
Cabinet
Wall
Cabinet
Wall
Cabinet Base
wall
MOUNTING TEMPLATE
Cabinet
Wall
To Next Page
Loading...
Need help?
General
