9
Step 3.
Insert the batteries into the battery
compartment by lifting up the tabs.
Drill a 1/4" hole in the wall a few inches
away from your filtration system. Place
the anchor inside the hole and then
fasten the battery compartment to
the wall by screwing it into the anchor.
You can also use the tape on the back
to install it to the wall.
Drill 1/4" Hole
Anchor
Screw
Insert the battery pack cable into the manifold.
! CAUTION - To avoid the risk of
personal injury, wear safety glasses
and cut resistant gloves with
non-slip grip when drilling.
Tape
To Next Page
Loading...
Need help?
General
