Need help?Do you have a question about the Kraus Nolen KPF-1673SFSMB and is the answer not in the manual?
General| Brand | Kraus |
|---|---|
| Model Number | KPF-1673SFSMB |
| Spout Height | 8.5 inches |
| Flow Rate | 1.8 GPM |
| Number of Handles | 1 |
| Handle Style | Lever |
| Installation Type | Deck Mounted |
| Number of Holes Required | 1 |
| Deck Plate Included | Yes |
| Material | Brass |
| Faucet Type | Pull Down |
| Spray Functions | Stream, Spray |
| Certification | cUPC |
Remove faucet mounting hardware, including screws, nut, and rubber/metal washer, from the mounting pipe.
Install faucet with deck plate for three-hole configurations, using sealant if needed for proper fit.
Install faucet for single-hole configurations; deck plate and sealant are not required for this setup.
Insert faucet body into countertop or deck plate, then secure with mounting hardware from underneath.
Adjust faucet body orientation and tighten mounting nut and screws until snug for stability.
Connect spray hose to quick connector and attach weight to the lowest vertical point on the hose.
Connect waterlines to hot/cold copper lines and angle stops, ensuring a snug fit and checking for leaks.
Remove spray head, run water to flush debris for 60 seconds, and verify washer installation.
Inspect all connections for leaks and retighten fittings as necessary to prevent water escape.
To Next Page