8
Step 5: Flush faucet
Step 6: Flow Regulator Replacement
This faucet ships with a (WHITE)1.8 GPM
ow restrictor installed. An optional
(BLACK) 2.2 GPM ow restrictor is also
included in the box.
Flow Rate Modication:
1. Disconnect the quick connect (2) and
unthread the (1-WHITE) ow restrictor
2. Replace with the 1.8 GPM restrictor
(1-WHITE) with the 2.2 GPM restrictor
(1-BLACK).
3. Reinstall the quick connect assembly.
Pull the hose assembly out of the spout and
remove the spray head by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into
the sink and turn the faucet on to the warm
position where it mixes hot and cold water.
Flush the water lines for one minute. This
Fushesaway any debris that could cause
damage to internal parts. Check for leaks.
Re-tighten any connections if necessary, but
do not overtighten. Reinstall the spray head
by hand tightening it back onto the spray
hose.
After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
NOTE: In compliance with CEC standards, this faucet is designed with a 1.8 gpm ow
rate. At your discretion, you may modify the product with the included 2.2 gpm
restrictor. Please note that doing so will remove the capability of this product to meet
specic low-ow standards. Kraus is not liable for any alterations made to the product
post-sale, and highly advises that you consult with your local or statewide plumbing
enforcement agency prior to any modication.
1
2
1
2
1
To Next Page
Loading...
Need help?
General
