KRAUSE & BECKER 60446 User Manual

ITEM 60446
Visit our website at: http://www.harborfreight.com
Email our technical support at: productsupport@harborfreight.com
NOTICE
CLEAN IMMEDIATELY
Clean the Spray Gun IMMEDIATELY
after EVERY use, in between coats,
and when it will be idle for
more than 5 minutes.
Delayed or inadequate cleaning will
permanently clog the Spray Gun.
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the
back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference.
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
Copyright
©
2014 by Harbor Freight Tools
®
. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein.
Tools required for assembly and service may not be included.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
REV 15c

KRAUSE & BECKER 60446 Specifications

General

Type	Airless Paint Sprayer
Maximum Pressure	3000 PSI
Voltage	120V
Hose Length	25 feet
Tip Size	0.015 in

Summary

SAFETY

WARNING SYMBOLS AND DEFINITIONS

IMPORTANT SAFETY INSTRUCTIONS

Crucial safety guidelines for operating the tool, covering general precautions.

Electrical safety

Precautions related to the use of electricity and power tools.

Personal Safety

Advice on personal protective equipment and safe operating practices.

Tool Use and Care

Specific Safety Instructions

Grounding

Information and warnings regarding proper electrical grounding for safety.

OPERATION

Before First Use

Spray Gun Setup and Adjustment

Steps for setting up and adjusting the spray gun for optimal performance.

Material Preparation and Filling

Fluid Adjustment

Spraying Technique

Best practices and methods for effective spray application.

CLEANING

Solvent Selection

After Every Use

Step-by-step instructions for cleaning the spray gun after use.

Nozzle Assembly Cleaning

MAINTENANCE

Inspection

Troubleshooting

Common problems and their solutions for the spray gun.