Kreg KCS-100 - Install Cabinet Brackets

5
2
Install Cabinet Brackets
a. Install the cabinet brackets (A) on the top of the wall cabinet (1) with the back of
the bracket 1-1/2 in. (3.81 cm.) from the back of the cabinet using the supplied
3/4in. screws (AA). Do not to attach to end grain of cabinet sides.
A
1
AA
1-1/2 in.
(3.81 cm)
A
1
AA
1-1/2 in.
(3.81 cm)
1
Note The top of the cabinet must be ush with the sides. If it isn’t, cut a scrap piece
of plywood or lumber (1) the correct thickness to make it ush and attach securely to
the top. The cabinet top must also be 1/2 in. (1.27cm) thick or thicker. If the cabinet
is 24in. (60.96 cm) wide or smaller, two brackets should be sufcient. More brackets
may be needed if the cabinet is wider, taller, or deeper than a typical wall cabinet.
1
1/2 in.
(1.27 cm)