NK8090
Version 1 - 4/2013
R
www.kregtool.com • 800.447.8638
Insert Plate
Precision Router-Table
INSTALLATION INSTRUCTIONS
Item # PRS3034
[Fits Triton TRA001 and MOF001, all Porter-Cable 7500 series*]
Item # PRS3036
[Fits Bosch 1617, Porter-Cable 690 and 890 series]
Item # PRS3038
[Not drilled]
*Lock-down screw holes and countersinks must be
enlarged for Porter-Cable 7500-series routers.
See the section Before you start in these instructions.
Parts:
• Insert Plate
• (3) Reducing Rings: 1", 1
3
⁄16" (guide bushing), 2⅝"
• Ring Wrench
• (4) ¼-20 x 1¾" fl athead machine screws (lock-down screws)
• ¼-20 x ¾" set screw
• Brass starting pin
• ⅛" hex wrench
• Router-base mounting screws (pre-drilled insert plates only)
WARNING: This product contains one or more chemicals known
to the State of California to cause cancer and birth defects or
other reproductive harm. Wash hands after handling.
Tools Required:
• Phillips Screwdriver
• Masking Tape
• Double-faced Tape
• Drill press
• Drill Bits, Countersink Bit
• Router, top-bearing pattern bit
To Next Page
Need help?
General
