Kreg Pro Series - Table of Contents

To Next Page

To Previous Page

Table of Contents

Congratulations on choosing a Kreg Pro Series Pocket Hole Machine!

Be sure to read the instructions and the safety warnings completely before using this machine.

TABLE OF CONTENTS .....................................................................................1

WARRANTY ......................................................................................................2

SAFETY INSTRUCTIONS .................................................................................3-6

DK1100 FE / DK3100 QUICK START GUIDE ...................................................7

DK1100 FE PARTS DIAGRAM ..........................................................................8

DK3100 PARTS DIAGRAM ...............................................................................9

DK1100 FE (Electric Model) / DK3100 (Electric Model) ....................................10-13

Acrylic Top /20 Amp Outlet / Changing Drill Bits .....................................10

Swing Stops / Adjusting The Machine For Stock Thickness ....................11

Clamping Cyclinder Height / Feed Rate / Clamping Duration ..................12

Belt Tension .............................................................................................13

DK1100 TP / FP (Pnuematic Models) ................................................................14-19

DK1100 TP / FP QUICK START GUIDE ............................................................14

DK1100 TP / FP PARTS DIAGRAM ..................................................................15

Acrylic Top / Swing Stops / Changing Drill Bits ........................................16

Adjusting The Machine For Stock Thickness ...........................................17

Clamping Cyclinder Height / Feed Rate / Clamping Duration ..................18

Air System Preﬁ lter / Air System Lubricator .............................................19

Notes ................................................................................................................. 20-22

Indicates the PHASE (HOT)

wire from the powersource

Indicates the NEUTRAL

wire from the powersource

Caution,

refer to manual

Earth Ground

Connection

Make sure all power sources have been disconnected

from this machine before opening the electrical box.

Symbols:

Other manuals for Kreg Pro Series