Krell KPS 28c 5
The abbreviated procedures in this Quick Start
section enable you to connect and operate your
KPS 28c quickly to enjoy its basic features. To
access the full array of available features for the
KPS 28c, please read the entire owner’s refer-
ence manual. Numbers in parentheses refer to
Figure 1 on page 6, Figure 2 on page 8, and
Figure 3 on page 10.
INPUT AND OUTPUT
CONNECTIONS
IMPORTANT
Make sure all components and power sources
are off before connecting inputs and outputs.
When switching between active sources,
always lower the volume to off or mute the out-
put. This ensures that the next source played
does not damage your system with a high out-
put transient.
Analog Output Connections
Connect the Krell CAST cables from the left and
right Krell CAST 4-pin outputs (13) on the KPS
28c back panel to your CAST-enabled preamplifi-
er. For balanced or single-ended operation, con-
nect the interconnect cables from either the left
and right balanced (14) or the single-ended (15)
outputs on the KPS 28c back panel to either the
balanced or the single-ended inputs on your pre-
amplifier. (The remaining outputs can be connect-
ed to another preamplifier in a different system.)
Note
You can set up the KPS 28c to play a musical
selection in three different areas. Connect the
CAST output to a CAST-enabled system in one
listening area, the balanced output to a system in
a second listening area, and the single-ended
output to a system in a third listening area. The
musical selection will play simultaneously in all
three areas.
Digital Output Connections
Connect the cables from the optics output (16) or
coaxial output (17) on the KPS 28c back panel to
your digital recorder or the digital input on your
preamplifier.
POWER ON
1. Connect the AC power cord to the IEC power
connector (20), then connect the AC power
cord to the wall socket. The KPS 28c is in the
stand-by mode. The red stand-by LED (3)
illuminates.
2. Press the power button (4) or pwr key (22) to
switch the KPS 28c from the stand-by to the
operational mode. The blue power LED (5)
illuminates and you hear a click. The KPS
28c is ready to play music.
TO PLAY A COMPACT DISC
1. Use the open/close button (2) or open key
(23) to open the compact disc transport (1).
2. Place a compact disc on the transport.
3. Use the open/close button (2) or open key
(23) to close the compact disc transport (1).
Playback automatically begins from the first
track. Adjust the system volume through your
preamplifier or amplifier.
4. Press the stop button (11) or key (28) to end
compact disc playback.
Note
You can also begin track playback by pressing
the play button (12) or key (29), or select a track
using the direct track access keypad (26), the
track forward and back buttons (8, 9) or keys (30)
or the search forward and back keys (31).
Quick Start
To Next Page
Loading...