D. DUST COVER INSTALLATION
1. Looking at the front of the MD-10, locate the two
black hinge block assemblies on the rear left and right
corners. (Refer to location diagram)
2. Locate the hinge pin on the back of each hinge block
assembly and pull them out gently until they are fully
extended.
t3
h.
Open the flap only on the protective sleeve and locate
e three cover pins.
4. Place the cover over the unit and insert the cover into
the hinge block assemblies with the cover in the ~
u~ri~ht ~osition. Make sure all three pins are in there
proper receptacles. Refer to location diagram on page 5.
5. Lock the cover into the hinge blocks .by pushing the
pins into them until they are fully seated.
6. Gently pull the cover forward and let it go, allowing
the cover to slowly descend.
CAUTION: Do not push the dust cover down. Its damp-
ing system allows a slow descent, and can be damagedif
force is applied.
7. Remove the protective sleeve.
4
To Next Page
Loading...