E. INPUT AND OUTPUT
CONNECTIONS
CAUTION: When making connections to this component
or any other, make sure tlie power amplifier is OFF.
CAUTION: Make sure all cable terminations are of the
highest quality, free from frayed ends, shorts or cold
solder joints.
1. Connect t.he left and right outputs of your source com-
ponents t.o the inputs on the KRC-2. The KRC-2 is
equipped with 4 single-ended inputs., 2 balanced capable
inputs, a single ended tape input and tape output.
The single-ended and balanced inputs are labeled S-1
througti S-4, B-1 a.nd B-2 respectively, to allow
customization in the set-up otyour system. There is. no
difference between the four single-ended inputs, or ~e-
tween the two balanced inputs.
2. Connect the output of the KRC-2 to the input of your
power amplifier. The KRC-2 has both Balanced outputs
via standard XLR type connectors and single-ended
outputs via standard-RCA type connectors.
Thepin assignment for the XLR connectors is:
pin _1-= shield (ground)
p!n 2 = non-inverting input (hot)
pin 3 - inverting input
NOTE: The RCA center conductor for each channel is
wired in para!lel with pin 2, the non-inverted output.
Only one of these outputs should be connected to a single
stereo amplifier.
NOTE: When connecting inputs or outputs to the KRC,
remember the balanced connections will have 6dB of
gain .m.ore than the single-ended connections. When level
matching is critical in your install, keep this specification
in mind.
6
To Next Page
Loading...
