Operating the Standard KPE, continued
Krell KPE 11
6. To alter loading from the 100 Ohm factory setting, set one loading
switch from each loading switch bank to the CLOSED (on) posi-
tion to obtain the desired setting. The loading switch banks are
situated on the left and right of the circuit board.
7. The loading switches are labeled as follows:
1 10 Ohms
2 25 Ohms
3 47 Ohms
4 100 Ohms
5 249 Ohms
6 475 Ohms
7 825 Ohms
8 1000 Ohms (1 K)
All open 47000 Ohms (47 K)
Each switch bank is labeled OPEN on one side. When a rocker switch on
the switch bank is depressed toward the side labeled OPEN, the switch is
OPEN, or off. When a rocker switch is depressed away from the side
labeled OPEN, the switch is CLOSED, or on.
If the manufacturer does not supply a loading value, use 100 Ohms
(switch 4) on both channels.
Experiment with different types of loading until you find the one that sounds
best. Always have one switch CLOSED (on) for both channels.
8. Place the topcover back on the Standard KPE and replace the
topcover screws.
LOAD SETTINGS
Notes
To Next Page
Loading...
