Need help?Do you have a question about the Krohn-Hite 523 and is the answer not in the manual?
General precautions for safe operation, service, and repair of the instrument.
Details on connecting the instrument to an electrical ground and protective earth.
Warnings against operating in hazardous areas, contact with live circuits, modifications, and handling damaged units.
Outlines the calibration process, required equipment, and N.I.S.T. traceability.
Detailed specifications for DC voltage and current output ranges, accuracy, and stability.
Covers temperature coefficient, noise, linearity, regulation, current limits, warm-up, and calibration details.
Guide for initial setup, including voltage selection and fuse installation.
Step-by-step instructions for selecting the correct line voltage for operation.
Instructions on how to safely install the correct fuses for the instrument.
Describes the Crowbar function and how to set voltage values.
Instructions for entering current values, including modifiers and range.
How to set compliance voltage limits for output.
How to set delta values for voltage or current output modification.
Describes the output terminals and their usage for 4-wire accuracy.
Guidance on making connections to minimize thermal EMF and ensure accuracy.
Step-by-step guide to setting the instrument's GPIB address.
Steps for Auto Zero Offset Calibration and output voltage verification.
Procedure for checking output current using the PCR100 resistor.
General| Output Impedance | 50 ohms |
|---|---|
| Power Supply | 115/230 VAC, 50/60 Hz |
| Weight | 20 lbs |
| Type | Function Generator |
| Sweep Width | Up to 1000:1 |
| Dimensions | 5.25" H x 19" W x 12" D |
| Distortion | <0.1% |
To Next Page
