Need help?Do you have a question about the Krohn-Hite 526 and is the answer not in the manual?
Provides an overview of the Krohn-Hite Model 526 DC Voltage/Current Source/Calibrator.
Details voltage and current ranges, resolution, accuracy, stability, and other technical parameters.
Describes each control and function of the Model 526.
Explains how to change voltage settings and the fuse for AC line voltage.
Details options for placing the 526 on a benchtop or mounting in an equipment rack.
Provides initial steps for powering on and setting the output voltage/current.
Explains how GPIB enables connection of instruments and the use of software drivers for control.
Details compatibility with older models and how to select protocols.
Covers interface capabilities, messages, commands, and data string formats for GPIB.
Explains how the Model 526 emulates older Models 520, 521, and 522 for remote operation.
Details address setting and interface messages for 522 protocol emulation.
Enables emulation of the Analogic/Data Precision 8200 protocol for remote operation.
Provides steps for connecting, configuring, and using the Model 526 on a LAN.
Covers connecting through a network or directly to a PC.
Contains operational and verification tests for checking the Model 526's operation and accuracy.
Recommends a 2-hour warm-up period for maximizing performance and stability.
Lists the necessary equipment for performing incoming acceptance tests.
Details preliminary setup steps for the Model 526 and the multimeter.
Outlines procedures for output voltage and current checks to verify accuracy.
General| Output Impedance | 50Ω |
|---|---|
| Power Supply | 115/230 VAC, 50-60 Hz |
| Type | Function Generator |
| Waveforms | Sine, Square, Triangle |
| Output Amplitude | 0 to 10 Vp-p |
| Sweep Range | 1000:1 |
To Next Page
