Please do not use transformer oil as they can contain substances
affecting operation and user health
1.
Heater intended application and technical data
The universal oil heater type MTM 52 is designed to heat industrial rooms not covered with central heating
systems (workshops, car repair shops, industrial shops, warehouses, storage buildings, basements, garages,
etc.).
The heater can operate using most waste oils of mineral and plant origin, e.g. engine, gear, hydraulic, fuel oil,
with maximal density in temperature of 15°C equal to 860 kg/m3 and with ignition temperature exceeding
56°C.
TECHNICAL SPECIFICATIONS:
MTM 52
Minimum heating performance kW 30
Maximum heating performance kW 52
Minimum oil consumption kg/h 2.5
Maximum oil consumption kg/h 5.2
Heated air flow m3 5500
Power supply V/Hz 240/50Hz
Power intake W 300
Flue diameter mm 150
Width cm 60
Height cm 127
Length cm 120
Weight kg 120
*
Calorific effect specified for fuel with the following parameters:
•
calorific value = 42.6 MJ/kg.
•
density at temp. max. 15°C = 860 kg/cm
3
.
In case of higher parameters, the calorific effect can be increased even up to 55 kW.
2.
Environmental conditions
The universal oil heater type MTM 52 must be stored in the following conditions:
temperature from -20°C to 85°C
relative humidity < 85%
pressure < 1200 hPa
dust free
environment free from chemical contamination.
3.
Conditions of Using
temperature from 0°C to 30°C
relative humidity < 85%
pressure < 1200 hPa
IP level IP21
Noise <70dB
To Next Page
Loading...
