6
The following tools and materials are needed to finish the installation:
Electric d rill
Drill bit
Cross head screwdriver
Flat head screwdriver
Pencil and ruler, to mark the position for installation
Pre-Installation Calculations:
Stand-alone installation（table 1）
SAFETY WARNING
THE HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES WHEN REMOVING ANY
PARTS FOR INSTALLING, CLEANING OR SERVICING.
Preparation before Installation:
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.
To Next Page
Loading...
