KRUG+PRIESTER EBA 5255 - Page 45

- 45 -
28.
   
.)  (
(A    )
   .
•
     
)
(
    
     . 
•
  
)     (
•
.   
 ! ! X
     
.)  (
   
•
     
     
•
.(A)   
  . ¼ 
28.
   
.)
  (
(A    
)
   .
•
     
)
(
    
     . 
•
  
)     (
•
.   
 ! ! X
     
.)
  
(
   
•
     
     
•
.(A)   
  
. ¼

Replacing the cutting stick (not the blade).
• Turnthebladeadjustingscrew(A) to the
 leftuntilitstops.(Otherwisetherstcutwill
be too deep).
• Remove the cutting stick according to top
picture.
• Turn the cutting stick (the non-used side
must be near to the blade) and plug it into
the holding bolt.
Danger! Risk of injury!
Cutting test after replacing the cutting
stick (not the blade)
• Insert the paper and release the cut.
• If the last sheet of paper is not cut along
the entire length turn the blade adjusting
screw(A)¼turntotheright.
• Ifthelastsheetisstillnotcompletelycut
repeat this process until the last sheet is
cut along the entire length.
Blade and cutting stick replacement