c
1. Turn the selector switch to the
“prog.’
setting. The
R
symbol will flash
intermittently in the display area.
:
2. Set the hour and minutes in which you
would like the brewing process to
commence by pressing the
‘h’
and ‘min’
buttons respectively (see figure
12).
“Wake-Up” time is now set.
To enjoy delicious “wake-up” coffee that is
freshly brewed and hot, first set the “wake-
up” time (see “Setting Wake-Up” Time).
1. Put in ground coffee.
2. Fill the water chamber to the desired
number of cups.
3. Place the carafe back on the warming
plate.
4. Turn the selector switch to the “auto.”
setting (see figure 13). The
R
symbol will
remain constant in the display, indicating
that the coffee-maker has been
programmed.
5. At the pre-programmed time, the
indicator light will illuminate, indicating
that the brewing process has begun.
NOTE:
If the selector switch is left in the ‘auto.”
position, the coffemaker will turn itself on
everyday at the pre-programmed time. If
you do not wish for this to occur, turn the
coffeemaker to the “off’ position (“0”) after
each use.
The programmable auto shut-off feature
allows you to keep coffee hot for up to 5
hours, and to shut off automatically, to suit
your needs. The auto shut-off will initially be
set to shut-off after 1 hour, unless otherwise
programmed. Auto shut-off will be effective
not only when you are manually preparing
coffee, but also when used with the wake-up
timer.
When you first plug in the coffeemaker, the
auto shut-off will be programmed for 1 hour.
To adjust the keep warm time:
0
Turn the switch to the “off” position.
0
Press the “min.” button. The blinking cup
will appear in the display and auto shut-
off will be set at 1 hour.
0
You can increase the keep warm time in
increments of 1 hour, up to 5 hours by
keeping the “min.” button pressed and
additionally pressing the “hours” button.
0
Once you have programmed the keep
warm time, it will be stored in memory
until manually changed.
0
If no keep warm time is set, the
coffeemaker will automatically shut itself
off after 1 hour.
The KRUPS “Crystal
Arome”
and “Crystal
Arome Time” coffeemakers feature a unique
filtration indicator that alerts you when it is
time to change the “Crystal Clear” charcoal
filter (after each 80 cycles).
At the same time, the indicator tells you that
your coffeemaker should be decalcified
(see “Decalcifying”).
9
To Next Page
Loading...
Need help?
General
