Click here to see steps 12-19.
1. Espresso function
For best results, we recommend that you first pre-heat the accessories (filter holder, filter basket and cups) without
putting in ground coffee. To do this:
.Fill the water container with fresh, cold water (1) (2) (3) and turn on the appliance (5).
.Put the filter holder and an empty filter basket in place (11) (6) (7) (8), and place the espresso cups underneath.
As soon as the appliance reaches the correct temperature the orange indicator light will go out.
.Turn selector to the LP setting (9).
-
. When the cups are full of hot water, reset the selector to the 0 setting.
After making your first espresso and the appliance is hot, the espresso cups can then be pre-heated on the cup
warming plate.
Preparing an espresso:
.Fill the water container (1) (2) (3) and turn on the appliance (5).
. Put the filter basket for one or two cups into the filter holder (11).
.Place some ground coffee in the filter basket, at the same time tamping it down firmly; the coffee should reach the
lip of the filter (12) (13).
. Remove any ground coffee which is lying around the rim of the filter (4).
.Replace the filter holder into the machine. Turn the filter holder until it is firmly locked into place (15).
.Place one or two espresso cups beneath the filter holder.
As soon as the appliance reaches the correct temperature the orange indicator light will go out.
. Then turn the selector tot he .!:e setting (10).
. When the cups are full, reset the selector to the 0 setting.
.Remove the filter holder with the filter basket from the machine, and remove the coffee grounds (17).
The filter basket can be refilled to make more espressos.
If you are preparing more than one cup of espresso, disregard the orange thermostat light. It simply indicates that
To Next Page
Loading...
Need help?
General
