espressos are being prepared one after the other, the drip tray should be emptied from time to time (about once
every 7 -8 espressos). If necessary, clean the drip tray and its grid (21) (22) with water and a little non-abrasive
dishwashing liquid, rinse and dry. When reassembling the machine, ensure that the plastic baffle lining is in the
right place (23).
. The brewing head, the filter basket and the filter holder
These must be cleaned after each use. All you need to do is wipe a damp cloth over the brewing had of your
appliance and to wash the other accessories in water and a little nonabrasive dishwashing liquid, rinse and dry.
If the brewing head is heavily clogged up, unscrew the strainer using a coin, clean it and refit it, pressing down
firmly (24).
When your espresso machine is not being used, do not leave the filter holder on the appliance to prevent wear on the
gasket.
.The cup warming plate: remove this to clean it with water and a little non-abrasive dishwashing liquid, rinse and
dry (25).
. Steam nozzle: wipe with a damp cloth after each use.
Important:
Clean the steam nozzle each time you have immersed it in milk, otherwise the inside of the nozzle becomes clogged
with milk particles. Allow the steam to escape into a wet cloth for one or two seconds after frothing milk. This will
flush out any milk residue.
.Perfect Froth attachment: For more through cleaning of the Perfect Froth attachment, you can be dismantle it.
.Remove parts A and C from the metal tube B (27).
.Clean all three parts with hot water. If need be, unclog the opening of part A using a fine needle. Be careful not
to enlarge the opening.
.Be careful with the little plastic nozzle cap (part A) when you replace the Perfect Froth attachment.
. Jfthe steam nozzle becomes clogged for any reason, use a paperclip to clear out any milk residue from the steam
nozzle (26).
. Percolation head gasket
From time to time this gasket must be cleaned:
. Put the filter basket in the filter holder and place the filter holder in the machine.
.Place a container under the filter holder.
.Turn on the appliance.
.Turn the selector to the setting .!:B.
.When the hot water starts to filter through, turn the filter holder slowly from left to right so that the water filters
through between the gasket and the filter.
To Next Page
Loading...
Need help?
General
