XP 5080
Autocappuccino
3x
2
3
4
1
max. 0,5 ltr.
2 sec.
5
1-800-418-3325
Can
Maintenance
Before carrying out maintenance remove
the plug from the outlet and allow the
appliance to cool down
Do not rinse / clean accessory parts in
the dishwasher
Wipe off with a soft
damp cloth
Clean the appliance regularly using mild,
non-abrasive cleaning agents only
Fill with fresh water before use Rinse regularly with hot water and mild dish soap, rinse
with clear water and dry off
Rinse regularly with hot water and mild dish soap, rinse
with clear water and dry off
Take autocappuccino accessory apart,
rinse it in hot water and dry it off
Suction opening blocked? – use a fine needle to unblock it
Accessories
*Measuring spoon / Nozzle key
KRUPS descaling agent
available in Krups retail stores
*Filter cartridge
(Art.-Nr. /
No. art. F088) (Art.-Nr./No. art. F054)
Empty after approx. 7 - 8 cups
Rinse with hot water after each use
Clean brewing head with a damp
cloth
When not in use -> remove from brewing head
If the brewing head is heavily clogged up, unscrew the brewing
grid using a coin, clean under running water, see «Descaling»
Troubleshooting
- Pre-heat cups with hot
water
Coffee is not hot enough
- Position filter holder correctlyEspresso leaks around the filter holder
- Fill the water tankPump is very noisy - Press firmly on the
water tank
- Fill water in the water tank
and press firmly in place
Water doesn’t run trough - Clean the filter and
the grid on the head
- Nozzle blocked?
-> use a fine needle to unblock it
The milk is not very frothy - Use very cold and
very fresh milk
- Try a different brand of milk
- Try a finer coffeeWater runs through too quickly - Fill with more grounds - Press down the coffee in the
filter holder more firmly
The espresso has no crema
(froth on coffee)
- Use very fresh coffee- Try a finer coffee
Lots of water on the coffee grounds - Fill with more grounds
Please read the TSM Success Manual® before operating the appliance. In order to obtain beverages of good
quality and to avoid damage or injury, follow the instructions precisely. Ensure that these instructions are given
to any other users of the appliance and that they are kept in a safe place so that they can be referred to at any
time. The appliance has been strictly checked for safety and correct operation. It left the factory in fault-free
working order.
Operating manual
Consumer Service
- Descale appliance
If the descaling procedure stops prematurely, a rinse has to be done before resetting.
Descaling
The descaling frequency depends on the water hardness and frequency of use
Only use KRUPS descaling agent (art. no. F054)!
*Delivered with the appliance
- Clean the filter holder
- Press down the coffee in
the filter holder more firmly
For domestic use only
The warranty does not include espresso machines which do not function, or do not function properly,
because descaling has not been carried out.
Changing filter cartridge
The filter cartridge provides clean, clear and fresh water for perfect tasting espresso by
reducing water impurities like chlorine. It also protects the espresso maker by reducing limescale
build-up. When using the Krups filter cartridge, one descaling per year will be sufficient.
Web site: www.KrupsUSA.com
Fill with water and descaling agent
*Milk container
- Plunge the total filter holder in hot
water during 15 min.
Filter holder very difficult to adjust
(1 or 2 cups)
Change filter
cartridge
Packaging Fill up
After descaling: Clean the system according
to section entitled “First use”
Place container under nozzle
Press and hold both buttons for 2 sec.
-> 10 Oz / 300 ml of water will be
pumped through steam nozzle
If buttons are flashing before
starting: Change filter cartridge!
Rinse water tank thoroughly -> set up
Place container under nozzle
-> press «hot water»
Place container below outlet -> press «small
cup»
Fill up
Press for 2 sec. hot water button
Appliance switches on and preheats
If appliance is ready press hot water button -> Descaling start (approx. 10 min.)
Disassemble the brewing grid with a coin / remove
frothing accessory and put in container after rinsing
Place container under nozzle
Turn appliance OFF
Place container under outlet Press «small cup» -> Descaling will continue until there is no water in tank
Appliance ready for rinsing
- Do not fill with
hot water,
mineralwater,
milk or other
liquids
Switches off and let the
machine cool down
Fill up
Replace tank: clean the system
according to section entitled “First Use”
Rinse brewing grid thoroughly -> set
up & re-attach
LIMITED WARRANTY
This Krups product is warranted for 1 year from the date of purchase against defects in material and workmanship. During
this period, the Krups product that, upon inspection by Krups, is proved defective, will be repaired or replaced, at Krups’
option, without charge to the customer. If a replacement product is sent, it will carry the remaining warranty of the original
product. This warranty does not apply to any defect arising from a buyer’s or user’s misuse of the product, negligence, failure
to follow Krups’ instructions, use on current or voltage other than that stamped on the product, wear and tear, alteration
or repair not authorized by Krups, or use for commercial purposes.
THE WARRANTIES SET FORTH HEREIN ARE EXCLUSIVE AND NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR USE, ARE
MADE BY KRUPS OR ARE AUTHORIZED TO BE MADE WITH RESPECT TO THE PRODUCT.
Some states do not allow limitation on how long an implied warranty lasts or do not allow the exclusion of incidental or
consequential damages, so the above limitations may not apply to you. This warranty gives you specific legal rights, and
you may also have other rights, which vary from state to state.
If you believe your product is defective, bring the product (or send it, postage prepaid) along with proof of purchase to the
nearest authorized Krups Service Center. (Please contact your respective countrys customer service department, indicated
below, for the address of the nearest authorized Krups Service Center.)
If you send the product, please include a letter explaining the nature of the claimed defect.
If you have additional questions, please call our Consumer Service Department:
USA: 1-800-526-5377;
Mon – Fri 8:30 a.m. – 7:00 p.m. (EST).
www.KrupsUSA.com
Canada: 1-800-418-3325;
Mon – Fri 8:30 a.m. – 4:30 p.m. (EST)
www.Krups.ca
Please note hours are subject to change.
Before calling the Consumer Service Department, please have the type number of your Krups appliance available. This
will assist in answering your questions. The type number is generally found on the bottom of the machine. It would be
helpful if you had the appliance available at the time of your call.
General correspondence can be addressed to:
USA:
Krups
196 Boston Avenue
Medford, MA 02155
Only letters can be accepted at this address. Shipments and packages that do not have a return authorization number
will be refused.
Canada:
Groupe SEB Canada Inc.
455 Finchdene Square
Scarborough, Ontario M1X 1B7
USA
1-800-526-5377
Web site: www.Krups.ca
Coffee quantity in cup is too small
or too large
- Re-programm coffee quantity as
described in Espresso section
- Recommend folding down
the paper as well
To Previous Page
Loading...
