How to unclog steam nozzle on Krups EA8108 Coffee Maker?
If the steam nozzle on your Krups Coffee Maker seems partially or completely clogged, ensure that the opening in the end piece is not obstructed by milk residue or limescale. Unclog the holes with the needle supplied with your appliance.
What to do if my Krups Coffee Maker detects a fault?
If your Krups Coffee Maker detects a fault, switch it off, disconnect it, remove the filter cartridge, wait a minute, and then restart the appliance.
Why is there water under my Krups EA8108 Coffee Maker?
If there is water underneath your Krups Coffee Maker, wait 15 seconds after the coffee has finished flowing before removing the water tank. Check that the drip tray is correctly positioned and not full. Ensure the drip tray is always in place, even when the appliance is not in use. Do not remove the drip tray during a cycle. Regularly clean the tank and its connection to prevent scale build-up, which can cause leaks.
Why does coffee dispense slowly from my Krups EA8108?
If the coffee from your Krups Coffee Maker dispenses too slowly, turn the coffee fineness dial to the right to make the grounds coarser. It could also depend on the type of coffee used. Run one or several rinsing cycles. Also, consider changing the Claris Aqua Filter System cartridge.
What to do if Krups EA8108 Coffee Maker auto-cappuccino set makes no froth?
If the auto-cappuccino set on your Krups Coffee Maker makes little or no froth, or doesn't take in milk, check that the accessory is correctly attached. Remove it and then replace it. Verify that the flexible tube is not obstructed or pierced and is correctly attached to the accessory to make it airtight. Rinse and clean the accessory.
Why does my Krups Coffee Maker steam nozzle make little milk froth?
If the steam nozzle on your Krups Coffee Maker makes little or no milk froth, use very fresh, very cold pasteurized or UHT milk for milk-based drinks. It is also advisable to use a cold container. If the results do not improve, try changing the brand of milk.
How to clear coffee grounds warning on Krups EA8108 Coffee Maker?
If, after emptying the coffee grounds collector, the warning message is still displayed on the screen of your Krups Coffee Maker, remove the coffee grounds collector and ensure it is empty and clean. Wait at least 6 seconds before replacing it, and ensure it is correctly installed.
Why is the coffee from my Krups Coffee Maker too weak?
If the coffee from your Krups Coffee Maker is too lightly colored or too weak, avoid using oily, caramelized, or flavored coffee. Check that the coffee bean container has coffee in it and that it is dispensing correctly. Decrease the drink volume and increase the drink strength. Turn the coffee fineness dial to the left to make the grounds finer. You can also make the drink in two cycles by using the 2 cups function.
How to make Krups Coffee Maker espresso hotter?
If the espresso or coffee from your Krups Coffee Maker is not hot enough, change the coffee temperature setting. Warm the cup by rinsing it with hot water before making the drink.
Why is no steam coming out of my Krups Coffee Maker nozzle?
If no steam comes out of the nozzle of your Krups Coffee Maker, empty the tank and temporarily remove the filter cartridge. Fill the water tank with mineral water high in calcium (more than 100 mg/l) and run successive steam cycles.
General| Type | Automatic Espresso Machine |
|---|---|
| Water Tank Capacity | 1.7 L |
| Bean Hopper Capacity | 260 g |
| Pressure | 15 bar |
| Color | Black |
| Power | 1450 W |
| Voltage | 220-240 V |
| Programmable | Yes |
To Next Page
