28
SETTINGS
All of the following options allow you to run the selected programs:
SETTINGS
You can set your water hardness between 0 and 4 by
pressing the + or – buttons . See “Measuring water
hardness” (below)
You can program automatic rinsing each time the appliance is
turned on by pressing the buttons and selecting ON.
You can choose the period after which your appliance will turn off
automatically (between 15 and 120 minutes by pressing the
buttons).
You can adjust the temperature of your coffee to three different
levels by pressing the buttons.
Return to coffee types menu.
Measuring water hardness
It is advisable to adjust the appliance according to the hardness of the water used. To check the water hardness, use
the stick supplied with your machine or contact your local water authority.
Degree of
hardness
Class 0
Very soft
Class 1
Soft
Class 2
Average hardness
Class 3
Hard
Class 4
Very hard
° dH < 3° > 4° > 7° > 14° > 21°
° e < 3,75° > 5° > 8,75° > 17,5° > 26,25°
° f < 5,4° > 7,2° > 12,6° > 25,2° > 37,8°
Appliance
settings
0 1 2 3 4
Installing the filter (Claris - Aqua Filter System cartridge) (32)
Note : To correctly install your cartridge, ensure that you follow the installation procedure each time you replace it.
(33) A mechanism which memorises the month in which the cartridge was changed and replaced (after a maximum
of 2 months): set the date using the cartridge cursor. Fit the cartridge in the tank (34). In the maintenance and settings
menu , the function indicator is located above the maintenance button . Using the navigation button ,
select the filter cartridge installation symbol . The symbols and the start button start to flash.
Place a 0.6 L container under the steam nozzle.
Press start . The start-up cycle begins and finished when the coffee types menu appears
To Next Page
Loading...
Need help?
General
