;,'--+:
.'
.,
.. '''.:,''. ", I" "':K.1'
I
' ..,'." "'...' "''''~' "-~r""'''' ~t.'''.)
;!,::::~J1" ' ."i "; , ~~('~;~;:,,:,:';',i
,I',i:} t" .,i~,;...,',',"~' . " c. >,
preparation. This is a result
splattering from occur-
Froth" will not work pro-
form the interval-controlled
ring.
perly.Therefore,never
'
r the steam/hot water
becomes clogged for decalcified you will see a
water pump condensing
'J'
nozzle and clean It In
any reason, remove the message In the display
. After milk Is frothed, set
immerse the top closure In
water into steam. As the
milk or froth.
warm, soapy water. screw that is holding the
panel that reads
thumping sound begins a
aside. If you like very
I
:' Use Caution when
steam nozzle In position
"DECALC". When this
few drops of water will
stiff froth, let the pitcher
If you wish to prepare ,.
removing the "Perfect
(Seefigure). Rinse
message appears you can
come out of the steam
sit for a few seconds.
espresso immediately after
Froth" from the steam- under the faucet with
still use the appliance but It
nozzle before entirely chan-
.Now you are ready to
using the steam nozzle the
Ing nozzle as it may
warm, water. If it is still
will continually remind you
ging over to steam.
add the frothed milk to
machine must be cooled
atlll be hot.
clogged take a sewing
that your machine needs
the waiting espresso.
down to the proper brewing
.Using a damp cloth,
needle and Insert it into
decalcifying.
Step 3
Pour the milk into the
temperature. (Wherf1ro-
, clean the steam/hot
the tip of the steam
.Tobegin, press "6" but-
cup by holding back the
thing milk the temperature
waternozzle.
nozzle to free any milk
Note:
ton (See figuree), A
froth with your spoon.
of the water is much hotter particles.
Decalclfier can be purcha-
Fill the remainder of the
than when you are brewing
Use Caution when
message will appear on
cup with the milk and
espresso). Toavoid burning
cleaning removing the
DO NOTPLACEANY
sed from KRUPS
the display,
f'
Consumer Service Depart-
then spoon on the fro-
the espresso, it Is neces-
ateamlng nozzle, It may
LOOSEPIECES IN THE
"Push/Steam" .
thed milk. In Italy it Is
sary to perform the pro-
ItIIibe hot.
DISHWASHER.
ment.
. At this time, take your
decure listed below:
,,\(
!
normally one part
pitcher of milk and insert
espresso to two parts Tolower the thermostat
HOW TO DECALCIFY
steam nozzle half way
milk plus froth.
temperature, insert the filter
CLEANING IMPORTANT
into the milk and press
If you are making more than
holder Into the machine and
.After use, empty the
Clean the steam nozzle
Please
follow the proce-
the ",, button (See
allow one cup of water
waterreservoir and drip each time after you have
dure listed below to
figure
e). Leavethe
one or two cups
of cappuc- decalcify your machine:
cino It Is recommended
without espresso to run
tray (See figureQl, e,
immersed it in milk, other-
steam nozzle in the milk
that you place the waiting
through the machine.
8). :
wise the Inside of the
.Turn machine "Off" and
for approximately 45-60
seconds depending on
espresso on top of the
..,-
.After preparing espresso
nozzle becomes clogged
unplug the appliance.
how much froth you
warming plate. You may
,.
ten times drip tray may
with milk particles. Allow
Allow it to cool before
want to place a cloth or
CLEANING THE PERFECT
,:
the steam to escape into a decalcifying.
want and the type of
need to be emptied and
milk you are using.
saucer over tl,1ecups to FROTH ATTACHMENT
cleaned.
wet cloth for one or two
. Remove filter holder, drip
help keep the espresso hot. It is strongly advised that
seconds after frothing milk.
tray, baffle, removable
Note:
Onceyouarefinished .youwipeoff themilk
.The water reservoir, drip
Any milk residue will be
grid, and water reservoir.
making the required residue which may have
tray,baffle, grid, filter
flushed out. See special
. Donotbring milkto a
amount of espresso, then collected on the "Pefect
holder and perfect froth
cleaning instructions for
.Turn the machine
boil (this will happen if
you can beg,infrothi milk Froth" and steaming nozzle
attachment should be "Perfect Froth".
completely upside down.
large bubbles start
for cappuccino.
Byfilling after the frothing process is
washed and rinsed in With a flat blade screw
forming at the surface of
the pitcher with milk 1/3to completed.
warm, soapy water on a
CAUTION
driver, remove the
the milk).
1/2full will yield enough
regular basis.
DO NOT TRY TO DISAS-
brewing sieve by turning
.Do not let the "Perfect
frothfortwo cupsof cap- Forathoroughcleaningof . Before replacing the drip
SEMBLE THE MAIN
it clockwise until the
Froth Attachment" touch
pucclno. If you need more the "Perfect Froth-Attach-
tray and grid make sure
BODY OF THE MACHINE.
sieve can be removed
the bottom of the pitcher.
froth, repeat steps 1-4. ment", remove the separate
the baffle has been
from the machine (See
parts A, 8, & C (See
placed Inthe drip tray
figuree &fJD).
Attention' figureCl».All partsshould
Step 4
. be rinsed In warm, soapy
properly (Seefigure e).
DECALCIFYING
.Turn machine upright
. After the milk is frothed,
The top closure of the "Per- water. If he small section of
. Rememberto clean the
This appliance has been
again and reinsert the
keep the "Perfect Froth"
feet Froth-Attachment" part A is clogged It can be
steam/hot water nozzle
designed with a built-in
drip tray, baffle, remov-
in the milk until you have
(SeefigureCl>part
A)has a opened using a fie sewing
with a damp cloth Imme-
monitoring system that will
able grid and water
pressed the "6" button.
very fine hole
whichdraws needle.
diatelyafter frothing
alert you when the
reservoirback into the
This willstop the steam-
air Into the milk. If this tiny
milk.
appliance needs to be
machine.
ing and prevent any
hole gets clogged, "Perfect. Removethe "Perfect
. If the steam nozzle
decalcified. When the
.Remove the water reser-
Froth-Attachment" from
appliance needs to be
voir and fill it to the
To Next Page
Loading...
