Krups Espresso Automatic EA90 Series

Questions and Answers

G
Gregory Henderson PhDAug 19, 2025
Why my Krups Espresso Automatic EA90 does not switch on?
- H
  Holly RodriguezAug 19, 2025
  If your Krups Coffee Maker isn't turning on when you press the power button, check the following: First, examine the fuses in your electrical installation. Next, ensure the mains plug is fully inserted into both the wall socket and the machine. If the socket seems faulty, have it repaired. If these steps don't work, the appliance itself may be faulty, and you should have it checked by a qualified technician. The cause may be a power failure, blown fuse, a faulty connection, or a problem with the appliance itself.
J
Julie LyonsAug 21, 2025
Why is there water underneath my Krups Espresso Automatic EA90?
- K
  Keith CunninghamAug 22, 2025
  If water is found underneath your Krups Coffee Maker, it's likely that the drip tray isn't correctly fitted or is overflowing. Make sure the drip tray is properly in place and empty it if it's full.
L
Lauren RamirezAug 25, 2025
Why is the coffee not hot enough from my Krups Coffee Maker?
- M
  Misty JohnsonAug 25, 2025
  If the espresso or coffee from your Krups Coffee Maker is not hot enough, check the coffee temperature in the “Settings” menu and increase the temperature. You can also programme your recipe using the “Favourites” function by increasing the temperature. Additionally, warm the cup by rinsing it with hot water before starting the preparation. This can happen if the coffee temperature is not set high enough or if the coffee cup is cold.
A
Ashley RobinsonAug 26, 2025
What to do if my Krups Espresso Automatic EA90 Coffee Maker doesn't make coffee with pre-ground?
- A
  Andrea CummingsAug 26, 2025
  If you used pre-ground coffee and your Krups Coffee Maker does not make coffee, use a mixture for espresso coffee machines. This issue may occur if you have poured too much pre-ground coffee or the pre-ground coffee is too fine.
S
Steven ColeAug 28, 2025
Why nozzle cleaning does not take place properly in my Krups Espresso Automatic EA90?
- L
  Lisa HouseAug 28, 2025
  If the nozzle cleaning of your Krups Coffee Maker does not take place properly, check that your preparation does not boil while heating or frothing. If it does, reduce the heating and/or frothing time. Check that the cleaning liquid bottle is not empty and carry out a manual cleaning. This issue may occur if there is no cleaning liquid or if the milk used is not suitable.
J
John WarrenAug 30, 2025
What to do if my Krups Coffee Maker displays a failure message?
- B
  Brandon RuizAug 30, 2025
  If your Krups Coffee Maker displays a failure message, hangs, or malfunctions, try these steps: Turn off and unplug the machine, remove the filter cartridge, wait 20 seconds, and then restart it. If the problem continues, record the message displayed on the screen and contact Krups customer service. This may be due to a software problem.
L
lmarshallSep 1, 2025
What to do if the 'empty coffee collector' warning persists on my Krups Coffee Maker?
- B
  Brittany CurtisSep 1, 2025
  If the used coffee collector has been emptied, but the warning message is still displayed on the screen of your Krups Coffee Maker, refit the used coffee collector and wait for at least 8 seconds before refitting the empty collector. This issue may occur if the used coffee collector is not fitted properly or if it was fitted back too quickly.
T
Tanya NelsonSep 3, 2025
What to do if the 'water tank' warning persists on my Krups Espresso Automatic EA90 Coffee Maker?
- J
  Jillian LongSep 3, 2025
  If the water tank has been filled, but the warning message is still displayed on the screen of your Krups Coffee Maker, check and unblock the float if necessary, reinstall the water tank properly until you feel some resistance, and rinse the water tank under running water and descale, if necessary. This can happen if the water tank is not fitted properly, the float at the bottom of the tank does not move freely, or the water tank is scaled up.
J
joshua02Sep 5, 2025
What to do if the 'drip tray' warning persists on my Krups Espresso Automatic EA90?
- C
  Charles GeorgeSep 5, 2025
  If the drip tray has been emptied, but the warning message is still displayed on the screen of your Krups Coffee Maker, clean and wipe the metal contacts at the back of the drip tray. The metal contacts may be dirty.
A
Andrea GreenSep 7, 2025
Why is the coffee from my Krups Coffee Maker too weak?
- O
  opetersonSep 7, 2025
  If the coffee from your Krups Coffee Maker is too lightly colored or too weak, check that coffee is present in the container and that nothing is obstructing the sensor (coffee bean blocking in the front, etc.), and reduce the quantity of water in the coffee. This can happen if there is not enough coffee in the coffee bean container or if too much water is used.

Krups Espresso Automatic EA90 Series Specifications

General

Series	EA90 Series
Pump Pressure	15 bar
Bean Container Capacity	250 grams
One-Touch Functions	Yes
Automatic Cleaning Program	Yes
Adjustable Coffee Strength	Yes
Adjustable Coffee Volume	Yes
Power	1450 watts
Type	Espresso Machine
Water Tank Capacity	1.7 L
Milk Frother	Yes
Material	Plastic
Color	Black
Operation	Automatic
Grinder	Integrated metal conical burr grinder