12
If you are preparing more than one cup of
espresso, disregard the orange thermostat
light. It simply indicates that the thermostat is
regulating the temperature.
ESPRESSO FUNCTION WITH THE SPECIAL “ ESE “
FILTER HOLDER
“ESE”, which stands for “Easy Serving
Espresso”, is a selected measure of coffee,
ground and pressed between two filter papers
making a coffee pod which is ready to use (for
example “illy pods). This system makes it
easy for you to prepare your espresso and to
clean the appliance.
The E.S.E. system was designed for making
Italian-style “espresso ristretto” or “short
espresso”. The amount of coffee is about two
ounce and the water should take 20 seconds
to run through.
We do not intend, or recommend, that
the ESE servings are used for making a
“long espresso”.
We recommend that you take care when
handling and storing the ESE servings so that
they do not become deformed.
For best results, we recommend that you pre-
heat the accessories (filter holder, filter basket
and cups) without any coffee. To do this:
• Fill the water container with fresh, cold
water (1) (2) (3) and turn on the appliance
(5).
• Put the empty ESE filter in place (7) (8) (9)
and position the espresso cup underneath.
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
• Then turn the selector to the
setting
(10).
• When the cup is full of hot water, reset the
selector to the O setting.
Once the machine has heated up, the
espresso cups can be pre-heated on the cup
warming plate (on top of the machine).
. Preparing an espresso:
Place the serving of “illy in the ESE filter
holder fitted with its own filter. The wording
“illy must be pointing towards the bottom.
Setting the ESE pod
Placing the ESE pod correctly will create a
richer, thicker crema.
Tear excess paper from pod at perforated
edge. Place the ESE pod with the RED
MARKING FACE DOWN (bend the paper
corners down).
LOCKING the handle TIGHTLY and PROPERLY
will avoid leakage from the filter holder and
ensure a better brewing cycle.
Place the filter holder inside the brewing head
and FIRMLY turn the handle as far RIGHT as
possible.
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
• Then turn the selector to the setting
(10).
• When the recommended quantity of coffee
has been reached (about two ounce) turn
the selector to the O position.
Remove the ESE filter holder from the brewing
head and throw away the used coffee pod.
NOTE: Other pods (such as those sold by
Starbucks ) can be used in your Krups Novo
3000 & 3000 Premium as long as they are
E.S.E. standard pods.
illy is a registered trademark of illy espresso of the
americas, inc.
Starbucks is a registered trademark of the
Starbucks Coffee Company.
2. STEAM FUNCTION FOR PREPARING CAPPUCCINO
AND
LATTE
The thumping noise which occurs while steam
is being produced comes from the
intermittent regulation of the pump and has
no effect on the proper working of the
appliance.
If you wish to make an espresso immediately
after using the steam function, the appliance
must first be allowed to cool down in order to
achieve the correct temperature for preparing
an espresso.
• To do this, place a container below the filter
holder (without coffee) and position
correctly, then turn the selector to the
setting (10).
• Allow the water to flow through until the
orange indicator light comes on. Then turn
the selector to the O setting.
To Next Page
Loading...
Need help?
General
